Correct installation of the Plastic Reinforced Hose can ensure safe use and avoid leakage or falling off. The following are the specific steps:
1. Check the hose
- Make sure the hose is not damaged, deformed or aged
- Measure the diameter of the hose and select a matching connector
2. Prepare the connector
- Use a stainless steel clamp or quick connector
- Wrap the raw tape around the connector thread to prevent leakage
3. Connection steps
- Cut the hose port flat to avoid skew
- Soak the hose port in hot water for 1 minute (for easy connection)
- Put the hose into the connector to a depth of at least 5 cm
- When fixing with a clamp, ensure uniform tightening without deflection
4. Pressure test
- Check the connection for leakage after water is passed
- Gradually increase the pressure to the working state
5. Precautions
- Avoid twisting and tangling of the hose during installation
- Check the clamp regularly for looseness
- Use high-temperature resistant hoses when delivering hot water
After installation, keep the Plastic Reinforced Hose naturally bent, and it is recommended to use elbow accessories for sharp bends. For the first use, it is recommended to run at low pressure for 1 hour to observe the situation.
